Synthetic high-performance gear oil for the food-processing and pharmaceutical industries with Kl¨¹berComp Lube Technology Kl¨¹bersynth UH1 6 is a synthetic high-performance gear oil based on polyglycol satisfying the growing requirements and increasing power density of modern gears. Kl¨¹bersynth UH1 6 includes Kl¨¹berComp Lube Technology*, i.e. it is based on especially high-grade raw materials and advanced additives, enabling maximum performance in the lubrication of all gear components. Kl¨¹bersynth UH1 6 oils are NSF H1 registered and therefore comply with FDA 21 CFR ¡ì 178.3570. The lubricants were developed for incidental contact with products and packaging materials in the food-processing, cosmetics, pharmaceutical or animal feed industries. The use of Kl¨¹bersynth UH1 6 oils can contribute to increase reliability of your production processes. We nevertheless recommend conducting an additional risk analysis, e.g. HACCP. Kl¨¹bersynth UH1 6 is certified according to ISO 21469, thus supporting compliance with hygienic requirements of your production. You will find further information about ISO Standard 21469 on our website www.klueber.com. Kl¨¹bersynth UH1 6 clearly exceeds CLP requirements according to DIN 51517-3. Corresponding gears can be switched to Kl¨¹bersynth UH1 6 without prior consultation with the gear manufacturer provided the general application notes are observed. Kl¨¹bersynth UH1 6 offers high scuffing load capacity. Gears are sufficiently protected against scuffing even at extremely high peak loads, vibrations or oscillations, or if no running-in was performed. The excellent wear protection of both gears and rolling bearings ensures that the service life calculated for the lubricated components is achieved, leading to lower maintenance and repair costs. The oil's high micropitting resistance of GFT ¡İ 10 according to FVA 54/7 offers sufficient protection to gears that are subject to high loads and would normally be susceptible to this type of damage. Kl¨¹bersynth UH1 6 offers a much longer service life than mineral oils due to the excellent ageing and oxidation resistance of the selected raw materials; thus service intervals can be extended and maintenance costs reduced. In certain applications, even lifetime lubrication is possible. The product's low foaming tendency and anti-corrosive properties enable problem-free gear operation. Freudenberg seals made of 72 NBR 902, 75 FKM 585, 75 FKM 260466 and 75 FKM 170055 are resistant to Kl¨¹bersynth UH1 6. Leakage and oil contamination are prevented. The excellent viscosity-temperature behaviour supports the formation of a sufficient lubricant film across a wide service temperature range, even at elevated and high temperatures. Therefore, a single viscosity grade can cover both low and high temperatures in many applications. The optimised friction behaviour enabled by the carefully selected base oils based on polyglycol reduces power loss and improves gear efficiency, especially in worm gears. Due to the optimised additives, wear values are reduced and a very low wear intensity according to DIN 3996 (calculation of load capacity of worm gears) is achieved. Kl¨¹bersynth UH1 6 is approved by Siemens-Flender, Siemens Geared Motors, SEW Eurodrive, Getriebebau Nord, Stöber Antriebstechnik, Lenze, ZAE Antriebssysteme, Baldor, Boston Gear, Bonfiglioli, Watt Drive, etc.
read more
